NETGEAR FS605v3 Guia De Instalacion página 3

Installing the Switch and Connecting the
Other Devices
1. Place the switch on a flat surface using either the attached feet or the provided vertical
stand.
2. For each device, insert one end of an Ethernet cable into the port in the device and
insert the other end into one of the Ethernet ports on the switch.
Note: If you have more than 5/8 devices to connect to this switch, you must connect them
to a hub or other switch and then connect that hub or switch to this switch.
3. Connect the power adapter's cord into the back of the switch and then plug the
adapter into a power source (such as a wall socket or power strip).
Warning: Use only the power adapter that came with the switch. Failure to use the power
adapter included with your product can damage the device and void your warranty.
4. Verify the following:
• The Power LED is lit.
• The corresponding port number for each connected and powered device should
light when link (connection), and flash when activity occurs.
Note: If any light doesn't operate as indicated, see the Troubleshooting section.
English
FS608v3 Switch
2
Modem
Router