Additional Functions - Whirlpool WPEC12MW Manual De Uso Y Cuidado

Enfriador de aire por evaporación
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Additional Functions

Turn signal sounds off:
Press and hold the SWING LEFT/RIGHT
and UP/DOWN buttons at the same time
ON/OFF
for 3 seconds to turn the signal sounds
off. To turn them back on, press and hold
COOL
SPEED
the SWING LEFT/RIGHT and UP/DOWN
buttons again for 3 seconds.
Protection Modes
The evaporative air cooler features three protection modes:
1. Water Tank empty
If the evaporative air cooler is in Cool mode and the water
tank is empty, the unit will shut off after 50 seconds and the
air cooler will beep for 10 seconds.
2. Water Tank removed
The water tank must be in place for Cool mode to operate. If
the water tank is removed while the Cool mode is on, the Cool
mode will turn off, an alarm tone will sound, and the fan will
continue to run.
3. Power Failure
In the event of a power failure, your evaporative air cooler
will immediately turn off. It will then operate at the previous
settings when the power is restored and the ON/OFF is
pressed. .
ON/OFF
Filter Indicator
The filter indicator will light after about 100 hours of use to
remind you to clean the air filter and evaporative media
cartridge. See "Care and Cleaning".
To reset the filter indicator, press and hold the Cool button for
three seconds.
Cleaning Reminder Indicator
The evaporative air cooler features a light to remind you to clean
it. This light will come on after 100 hours of use. To reset, press
and hold for 3 seconds. See Care and Cleaning for cleaning
instructions.
1
2
4
8
TIMER
SWING UP
DOWN
FILTER
1
2
4
8
COOL
SPEED
TIMER
For effective cooling, the water tank must be filled before using
Cool mode.
If the water tank is removed while the Cool mode is on, the
Cool mode will turn off, an alarm tone will sound, and the fan will
continue to run. This is normal.
SWING LEFT
RIGHT
1.
Remove the water tank
Remove the water tank by turning the water tank lock to the
unlocked position. Pull the water tank straight out from the
bottom back of the evaporative air cooler.
2.
SWING UP
SWING LEFT
Fill the water tank
DOWN
RIGHT
FILTER
NOTE: Fill the water tank with cool, clean water. The water tank
has a capacity of about 11.6 pints (5.5 L). Do not exceed the
maximum fill level.
Slide the water tank completely back into the Evaporative
air cooler and turning the water tank lock back to the locked
position.
For Added Cooling Power
For additional cooling power, add ice cubes to the water tank,
or use the ice packs (included with some models).
Using the Ice Packs
Simply place the ice packs in the freezer until completely
frozen, insert one at a time in a full water tank. Rotate the
thawed ice pack with a frozen ice pack for continued additional
cooling effect.
Filling the Water Tank
Water
tank
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wpec12mtWpec12rmwWpec12rmt

Tabla de contenido