Trouble Shooting - Predator D12 Manual De Instrucciones

Check the following before contacting technical support.
PROBLEM
The device does not work
Water removal capacity is too low
The device works, but reduces the
relative humidity insuffi ciently
Dehumidifi er is blowing out warm air
The display is not showing the
humidity set point
Water on fl oor
The dehumidifi er is noisy
33

TROUBLE SHOOTING

POSSIBLE CAUSE
The power is not connected
The water tank is full
The tank has not
been replaced correctly
Runtime is too short
Ambient temperature or humidity is
too low
The room is too big
There is too much ventilation
The air fi lter is clogged
Set humidity is higher than the
ambient humidity
The dried air is passed over heating
coils before it is blown into the room as
part of the dehumidifying process
The display shows the room relative
humidity not the set point
There is residual water in tank, and the
device is lurched too much by moving
The air fi lter is blocked or the device
is on an uneven surface
SOLUTION
Insert the plug into the wall outlet
Empty the tank
Replace the tank
Be patient and wait
It is normal that the device does not
dehumidify in these conditions
We recommend using a dehumidifi er
with a greater capacity
Reduce ventilation(e.g. close
windows and shut doors)
Clean the air fi lter
Set the humidity lower than ambient
humidity
This is normal, a dehumidifi er is not
an air cooler
Press the humidity control button
once to see the target relative
humidity
Be careful when move the tank
Clean the fi lter or put the device on a
fl at surface
www.glaziar.com / info@glaziar.com