Yardgard SELECT Instrucciones De Instalación página 5

2
STAGE 2: FENCE PANEL INSTALLATION
STAGE 2: PARTS LIST
TENSION WIRE (1000-034-747)
FENCE PANELS (1000-034-736)
PAGE 6
TOOLS AND MATERIALS
Installing Tension Wire
• Tape Measure
• Screwdriver (Phillips/Blade)
• Adjustable Wrench
• Wire Cutter
• Adjustable Pliers
• Cordless Drill
Installing Fence Panels
• Wire Cutter
TENSION WIRE (1000-034-747)
Tension Wire
K
200´ Roll
Panel-to-Wire Clip
FENCE PANELS (1000-034-736)
L 8' Fence Panel Section
M Panel Clip
YARDGARD SELECT - FENCE FRAMEWORK INSTALLATION INSTRUCTIONS
™
2
STAGE 2: FENCE PANEL INSTALLATION
STEP 1:
INSTALLING TENSION WIRE
• Position the tension band 3˝ from the ground (Fig. 12).
• Attach the tension wire ratchet (included in the Post Hardware
Kit) to the tension band and tighten carriage bolt using an
adjustable wrench (Fig. 12).
• Duplicate this step at the opposite corner, end, or gate post.
• Measure the distance between the two posts and add 1˝ to
that measurement. Cut tension wire to size. (Fig. 13)
• Thread tension wire through hole in first ratchet and wrap us-
ing adjustable wrench making 3 to 4 rotations (Fig. 13 and 14).
• Stretch tension wire to tension wire ratchet at the opposite end
of the fence line. Repeat the steps above and rotate until wire
is tight.
• Repeat for each fence line.
QTY.
1
100
QTY.
3
12
YARDGARD SELECT - FENCE FRAMEWORK INSTALLATION INSTRUCTIONS
™
Fig . 12 Tension Band Installation
Adjustable Wrench
Tension Band
3˝
Tension Wire Ratchet
Fig . 13 Tension Wire Insertion
Insert tension wire
through holes
Fig . 14 Tighten Tension Wire
PAGE 7