Getting Started; Battery Operation - HoMedics AromaSpa ARM-CAN1 Manual Del Usuario

Figure 1
J
K
I
BACK
F
Package Contents
Part Description
A Rock Tray
Oil Dish
B
C Heating Element (attached to E)
Flameless Candle (attached to E)
D
Base
E
F Aroma Oils
G Power Adaptor
H Rocks
I
Power Button
J Heat Indicator
Battery Compartment
K
(bottom of unit, not shown)
A
B
C
D
E
Quantity
1
1
1
1
1
2
1
1 Set
1
(battery not included)
1
1
4

Getting Started

Unpack the product. Be sure that all parts listed are included (Figure 1).
H

Battery Operation

Install/Replace Batteries
AromaSpa's Flameless Candle can operate in Battery Mode, without power adaptor, for
use of candlelight (Heating element will not activate in battery mode.) anywhere in your
home.
1. Be sure to disconnect POWER ADAPTOR (G) from BASE (E); and remove ROCKS
(H), ROCK TRAY (A) and OIL DISH (B) before turning AromaSpa upside down to
access BATTERY COMPARTMENT (K).
2. Open the BATTERY COMPARTMENT (K) located on the bottom of the unit (Figure 2).
3. Insert 3-AA batteries checking that the +/- polarity follows the direction of the
instructions inside the BATTERY COMPARTMENT (K).
4. Do not mix different types of batteries together (e.g. alkaline with carbon-zinc or old
batteries with new).
5. Close BATTERY COMPARTMENT (K) cover.
NOTE:
Remove the batteries if the product will not be used for a long time.
Battery Mode
1. In order for AromaSpa to function in battery mode, POWER ADAPTOR (G) must be
disconnected from BASE (E).
G
2. When AromaSpa is off, first press of POWER BUTTON (I) will activate FLAMELESS
CANDLE (D) (Figure 6). Second press of POWER BUTTON will shut AromaSpa off
completely.
NOTE:
Battery Mode operates flameless candle only.
Figure 2
(not included)
Figure 4
Figure 3
Step 2
Step 2
F
B
Step 1
Step 1
E
5
H
A
E