Transportation And Storage; Technical Data - GreenWorks BLG304 Manual Del Operario

• Make the surfaces wet before you clear the
unwanted material in dusty conditions.
• Look out for children, pets, open windows, and
cleaned cars during operation.
• Clean the machine.
• Discard the unwanted material when you complete
work.
5 MAINTENANCE
CAUTION
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Remove the battery pack from the machine before
maintenance.
5.1 CLEAN THE MACHINE
CAUTION
The machine must be dry. Humidity can cause risks of
electrical shocks.
• Clear the unwanted material out of the air vent with
a vacuum cleaner.
• Do not spray the air vent or put the air vent in
solvents.
• Clean the housing and the plastic components with
a moist and soft cloth.
6 TRANSPORTATION AND
STORAGE
WARNING
Remove the battery pack from the machine before
tranportation and storage.
6.1 MOVE THE MACHINE
• Only hold the machine with the handgrip.
6.2 STORE THE MACHINE
• Clean the machine before storage.
• Make sure that the motor is not hot when you store
the machine.
English
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service
center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
7 TROUBLESHOOTING
PROBLEM
The motor does
not start when
you pull the trig-
ger.
The machine
does not start.
The air does not
flow through the
tube when you
start the ma-
chine.
8

TECHNICAL DATA

Voltage
Air volume
Air speed
Weight (without battery pack)
Measured sound pressure level L
Measured sound power level
Guaranteed sound power level
Vibration
9 WARRANTY
(The full warranty terms and conditions can be found on
Greenworks webpage)
5
POSSIBLE SOLUTION
CAUSE
Make sure that
The battery pack
you tighlty install
is not installed
the battery pack
tightly.
in the machine.
The battery pack Charge the bat-
is out of power. tery pack.
The power switch
is defective.
Replace the de-
The motor is de- fective parts by
fective. an approved
service center.
The PCB board is
defective.
The air inlet or
Remove the
tube outlet has a
blockage.
blockage.
24 V DC
4.84 m³/min
176 - 226 km/h
1.5 kg
= 75.3 dB(A),
PA
K = 3 dB(A)
PA
L = 85.9 dB(A)
WA
L = 89 dB(A)
WA.d
＜ 2.5 m/s
2
m/s
EN
2
, K = 1.5