One-Piece Doors - Craftsman 139.53992 Manual Del Propietário

ONE-PIECE DOORS
Please read and comply with the warnings and
reinforcement instructions on the previous page.
They apply to one-piece doors also.
• Center the door bracket on the top of the door, in
line with the header bracket as shown. Mark either
the left and right, or the top and bottom holes.
• Drill 5/16" (0.78 cm) pilot holes and fasten the
bracket with hardware supplied.
If the door has no exposed framing, drill 3/16" (0.47
cm) pilot holes and fasten the bracket with 5/16"xl-
1/2" lag screws (not provided) to the top of the door.
NOTE: The door bracket may be installed on the top
edge of the door if required for your installation.
(Refer to the dotted line optional placement drawing.)
Drill 3/16" (0.47 cm) pilot holes and substitute
5/16"x1-1/2" lag screws (not provided) to fasten the
bracket to the doo_
HARDWARE SHOWN ACTUAL SIZE
© ©
Nut 5/16"-18 Lockwasher 5/16"
Carriage Bolt
5/16"-18x2-1/2"
Header Wall
2x4 Suppod
Finished Ceiling
Header
Bracket
Optional
Placement
of Door
Bracket
Door
Bracket
Vertical
Garage Door
Horizontal and vertical
reinforcement is needed for
lightweight garage doors
(fiberglass, aluminum, steel,
door with gtess panel, etc.)
(not provided).
For a door with no exposed framing,
or for the optional installation, use
5/16"x1-1/2" lag screws (not provided)
to fasten door bracket.
DOOr
Bracket
25