EN
User Manual
USB-C™ Premium Multiport Adapter
1
Safety Instructions
•
Read the user manual completely and carefully before use.
It is part of the product and contains important information for correct
use.
•
Keep this user manual.
It must be available for uncertainties and passing the product.
•
Do not open the housing.
•
Do not modify product and accessories.
•
Do not short-circuit connections and circuits.
•
Use product, product parts and accessories only in perfect
condition.
A defective device may not be put into operation, but must be protected
against further use.
•
In case of questions, defects, mechanical damage, trouble
and other problems, non-recoverable by the documentation,
contact your dealer or producer.
•
Install the system and devices attached to it in a way that
persons cannot be injured, or objects not be damaged for
example by dropping or stumbling.
Not meant for children. The product is not a toy!
•
Secure packaging, small parts and insulation against acciden-
tal use.
•
Avoid stresses such as heat and cold, moisture and direct
sunlight, microwaves, vibrations and mechanical pressure.
Heat storage:
•
Do not cover the product.
•
Keep enough space around all devices for a good ventilation
and free motion and to avoid damages.
2
Description and Function
2.1
USB-C™ Premium Multiport Adapter
This device extends an USB-C™ device with an Ethernet, HDMI™, VGA and Mini
DisplayPort connector as well as two USB-A 3.0 connectors, one USB-A 1.2 BC
connector, one USB-C™ PD connector (for charging), one 3.5 mm audio port, one
SD card slot and one microSD card slot.
2.2
Scope of delivery
USB-C™ Premium Multiport Adapter, User manual
2.3
Operating elements
1
USB-C™ plug
3
2x USB 3.0 socket (type A)
5
microSD card slot
7
USB-C
PD charging socket
TM
9
HDMI™ socket
11 RJ45 socket (8P8C)
2.4
Specifications
Article number
Input
Outputs
Max. output
USB-C™ PD charging socket
(PD = Power Delivery)
USB 3.0 socket, type A (total output)
USB BC 1.2 socket, type A
Maxi. resolution
HDMI™ / Mini DisplayPort socket
VGA socket
Data transmission rate
USB 3.0
SD 3.0 UHS-I
SD/SDHC/SDXC
Supported bandwidth
Operating temperature
Operating humidity
Storage temperature
Storage humidity
Weight (g)
Dimensions (mm)
Cable length (cm)
Tab.: Specifications
REV2020-09-17
V2.1 aw
Subject to change without notice.
2
USB 1.2 BC socket (type A)
4
3.5 mm audio port
6
SD card slot
8
VGA socket (15-pin)
10
Mini DisplayPort socket
62113
USB-C™ plug
HDMI™ jack | USB 1.2 BC socket (type A) |
2x USB 3.0 socket (type A) |
SD card slot | microSD card slot | USB-C
PD charging socket | RJ45 socket (8P8C)
| VGA socket (15-pin) | 3.5 mm audio port |
Mini DisplayPort socket
60 W @ 20 V
/ 3.0 A
10 W @ 5 V
/ 2.0 A
7.5 W @ 5V
/ 1.5 A (5 W @ 5.0 V
1.0 A, together for the remaining USB 3.0
sockets)
4K x 2 K @ 30 Hz
1920p x 1200p @ 60 Hz
5 Gbit/s
reading 70 Mbit/s / writing 90 Mbit/s
up to 128 GB
10 / 100 / 1000 Mbit/s
0 - +45 °C
10-90 % RH
-10 - +70 °C
10-90 % RH
198
137 x 75 x 17
16
3
Intended Use
We do not permit using the device in other ways like described in chapter
„Description and Function" or in the „Safety Instructions". Use the product
only in dry interior rooms. Not attending to these regulations and safety
instructions might cause fatal accidents, injuries, and damages to
persons and property.
4
Preparing
•
Compare the specifications of all used devices to ensure
compatibility.
•
Check the scope of delivery for completeness and integrity.
5
Connecting
•
Connect your devices to the ports of the USB-C™ Premium
Multiport Adapter using appropriate adapter or connection cables.
Fig. Connecting
The green status LED on the RJ45 socket lights up if a hardware connection exists.
The orange status LED on the RJ45 socket flashes when data transfer is taking
place.
Data transfer is possible in both directions for all ports except RJ45, Mini Display-
Port, VGA and HDMI
TM
Charging of connected devices is only possible at the housing sockets.
There are no operating elements to be operated before, during and after operation.
No software installation is required before or during operation.
Disconnecting and reconnecting the devices can be used to rectify faults.
Do not disconnect the power supply during data transmission to avoid possible data
loss.
Use only one video connection at a time to ensure proper operation of the product.
6
Maintenance, Care, Storage and Transportation
The product is maintenance-free.
NOTICE!
Material damage
•
Clean only with a dry, soft cloth.
•
Do not use cleaning agents and chemicals.
•
Store cool and dry.
•
Store the product out the reach of children and in a dry and dust-
protected ambience when not in use.
•
Keep and use the original packaging for transport.
7
Disposal Notes
7.1
Product
According to the European WEEE directive, electrical and electronic
equipment must not be disposed with consumers waste. Its components
must be recycled or disposed apart from each other. Otherwise contami-
native and hazardous substances can pollute our environment.
As a consumer, you are committed by law to dispose electrical and electronic de-
vices to the producer, the dealer, or public collecting points at the end of the devices
lifetime for free. Particulars are regulated in national right. The symbol on the pro-
duct, in the user`s manual, or at the packaging alludes to these terms. With this kind
TM
of waste separation, application, and waste disposal of used devices you achieve an
important share to environmental protection.
WEEE No: 82898622
7.2
Packaging
Packaging can be disposed of free of charge at the suitable collection
points – paper belongs in paper bins, plastics belong in yellow sacks and
glass belongs in used glass bins.
/
DE4535302615620
8
EU Declaration of Conformity
With the CE sign, Goobay
GmbH ensures, that the product is conformed to the basic European
standards and directives.
9
Symbols used
Direct current
For indoor use only
Recycling
- 2 -
.
®
, a registered trademark of the Wentronic
IEC 60417- 5031
IEC 60417- 5957
ISO 7001 - PI PF 066
by Wentronic GmbH | Pillmannstraße 12
38112 Braunschweig | Germany
62113
Goobay
®