Monitor Operation - miniland baby digimonitor 8 plus Manual De Instrucciones

English
To disable this function and view the monitored area continuously you must select
CAMERA mode on the camera.
5.2.1.2. Night Light OFF AUTO ON
When in the switch (9) is ON position, the night light will be ON continuously.
When it is switched to AUTO position, it will only be ON only when it is triggered
by sound. When it is switched to OFF position, the night light will be turned off.
5.2.1.3. Volume (High- Mid - Low)
(13) It is used to adjust the sound volume on Baby unit at a preferred level.
5.2.1.4. Transmission HI/LOW
(8) When it is switched to HI position, it can reach 300m in open field with its
original transmitting power. Whereas it is switched to LOW position, the transmitting
distance is about 150m in open field.

5.2.2. MONITOR OPERATION

5.2.2.1. Turn ON and turn OFF
· Turn ON:
Connect the AC power adapter to the frame and plug
the adapter into an electrical outlet. (100-240V, 50-60Hz)
Press Power Key at Lead 0.5 second, after several
seconds, the screen shows:
After power on, the photo frame will show the image
of the camera (please read "BABY MONITOR" section
to configure the camera and USB receiver to monitor
your baby)
NOTE: If the USB receiver is connected to the
photoframe but the camera is OFF, you will see the
screen black; please turn the camera ON to see the
image from the camera.
If the USB receiver is not connected, it will shows the
message "Please check if USB RECEIVER is plugged
in" and it automatically will go to the Monitor initial
page to select the desired page (please read "MODE
SELECT PAGE" section).
32