G Eneral Notes On Safety; Se Of The Machine For Purposes For Which It Is Intended; I Ncorrect Use; Ec Ce - SUHNER LGS 30 Manual Del Usuario

1. Notes on Safety
1.1 g
enerAl notes on sAfety
This operation manual is applicable for the machine LGS
30.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The machine is designed for marking/chisel of metal,
wood, plastic and the like.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Translations of the «EG-Koformitätserklärung (Original)».
Otto Suhner GmbH, Trottäcker 50, D-79713 Bad Säckin-
gen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side) com-
plies with the requirements under the Directive 2006/42/
EG. Applied standards: EN ISO 12100, EN ISO 11148.
Document Agent: T. Fischer. D-Bad Säckingen, 10/2019.
T. Fischer/Managing Division manager
2. Commissioning
2.1 P
rior to tAking the mAchine into service
Use oiled compressed air (see also air
quality under section 2.3). Observe nation-
al regulations.
2.1.1 f
itting of hose couPling
Fitting of hose coupling inside diameter min. 4.5mm
(available as optional accessory, item no. 90805400).
16
2.2 t
Aking the mAchine into service
2.2.1 t /t
urn on urn off
Switch on the tool by turning in the direction of the arrow
to the stop. Turn back to switch off the tool.
Before cutting off the compressed air supply, al-
ways set the machine to the «OFF» position so
that the tool cannot be reactivated inadvertently.
2.3 r

Ating dAtA

Pressure
Air consumption
Frequency storke
Sound pressure level EN ISO 15744 67dB(A), K=3dB(A)
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight with hose
2.4 o

PerAting conditions

Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3. handling / Operation
3.1 t
ools
Use only clean tools!
3.1.1 c /f
hAnging itting the tool
Loosen retainer with key.
max. 6.3bar
0.03m /min
3
30000min
-1
3.7m/s , K=0.9m/s
2 2
3/4/4
0.150kg