Important Safety Instructions - Sunbeam SB20 Manual De Instrucciones

IMPORTANT SAFETY INSTRUCTIONS:

1. 1.
Use the appliance only as recommended in this manual.
2. 2.
To avoid overload, do not operate another high wattage
appliance in the same outlet or extension. Do not use
extension cords to avoid overheating and risk of fire.
3. 3.
Do not immerse the unit, plug or cord in water to protect
against risk of electrical shock.
4. 4.
No detergent can be added into the water tank or it will cause
damage. Distilled or de-mineralized water is recommended.
5. 5.
Do not leave the steamer unattended while it is in operation;
particular close supervision is necessary when used near
children.
6. 6.
Make sure to fill the water reservoir before operating the
steamer. Always check the water level before and during
operation.
7. 7.
Do not lay the hose on the ground or wind it.
8. 8.
Refrain from touching the hot metal parts, hot water or steam
to avoid burns.
9. 9.
Allow the appliance to cool completely for at least 30 minutes
and drain the water tank and water reservoir before storage.
10. 10.
Move the appliance by grasping the telescopic pole. Do not
force the casters if they are stuck. Turn off the unit, and drain
the water tank and water reservoir before inspecting the
casters.
11. 11.
Always disconnect the appliance from the outlet before filling
or draining water. Be careful to avoid excess water spilling
from the water reservoir.
12. 12.
Unplug the unit from the outlet when not in use, when moving
unit from one location to another, and before cleaning.
S de PROBLEMA Y SOLUCIONES
PROBLEM REASON
La unidad falla El barco de vapor
de humear. Las no es conectado.
lámparas que
El Cortacircuitos
Indican no prenden.
de la casa/
Interruptor de
Defecto de Suelo
es tropezado o
Funde es soplado.
La unidad falla El aumento
de humear. Las mineral en la
lámparas que unidad.
Indican son
La cisterna es
encendidas.
vacía.
Excesivo La condensación
borbotando de en la manga.
Manga y Boca de
Vapor.
El vapor es El aumento
intermitente. mineral en la
unidad.
SOLUTION
Tape en el tomacorriente.
Verifique el tomacorriente.
Si usted necesita ayuda,
contacte a un electricista
calificado.
Siga el Quitar
instrucciones Minerales
de Aumento.
Rellene la cisterna.
Algún borbotar es un
efecto natural del proceso
de vapor.
Para borbotar excesivo,
extienda la manga para
permitir verticalmente
agua para desaguar atrás
en el Depósito de Agua.
Es normal para la
unidad para parar
periódicamente vapor
para unos pocos
segundos. Si el vapor
permanece lejos
por períodos más
largos, sigue el Quitar
procedimiento Mineral de
Aumento.