Charging Procedure - Weed Eater WE20VRB Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

20V Charger: WE20VCH
Input: 100-240V AC 50/60HZ 0.25A
Output: 20V DC 0.50A
1. Plug the charger into an AC power outlet.
2. Slide Charger over the Battery Pack Terminals. Make sure the Charger and Battery are fully
connected.
3. When the battery is charging, the LED will blink; when the battery is fully charged, the LED
will stop blinking but will remain illuminated.
Charging/Cargando/En charge
Fully charged/Lleno/Chargé
Keep the charger clean and clear of
debris. Do not allow foreign material into
the recessed cavity or on the contacts.
Wipe with a dry cloth. Do not use solvents,
water, or place in wet conditions.
Unplug the charger when there is no
battery pack in it.
Fully charge the batteries before placing
them in storage.
Store the charger at normal room
temperature. Do not store it in excessive heat.
Do not use the charger in direct sunlight.
Recharge at temperatures between 32 and
°
°
104
F (0 and 40
C). If the battery pack is hot,
CHARGER SPECIFICATIONS

CHARGING PROCEDURE

CHARGER MAINTENANCE
allow it to cool down before charging.
WARNING:
In order to avoid personal injury and the risk
of fire and electric shock, remove the battery
before adjusting, inspecting, or cleaning the
battery.
4

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

We20vch

Tabla de contenido