Publicidad
Idiomas disponibles
Idiomas disponibles
Attention:
1. The new water purifiers when you start using before,you should be turned on the water
about more than 30 minutes so as to obtain the normal water.
2. If you didn't have using the purifier,you should be repeated suitable flushing 2-5
minutes when you reuse until exhausion the saving water within in the water purifier.
3. To be used,you should pay attention to the situation of the effluent quality , inorder to
change the filter timely ,guarantee the water purification effect.
4. The total output capacity is about the input quality, If water purifier input quality is
better, the total output capacity will rise, the total output of the opposite water will
decline, the corresponding filter service life will be slightly shorter.
5. If you using the water purifier for the long-time ,the output capacity will gradualliy
decline,the water quality is qualified, please feel free to use.
6. On a regular basis to clean and replace filter.
7. If the water purifier has break down,please close the inlet value,cut off the input
water ,do not disassemble.
8. The users see to get often that observe its integrity so as to guarantee the security ,if
you goes out for a long time ,you must close the inlet value.
9. The range of water pressure:0.3 0.5MPa.
Faults and trouble shooting
Water tee is leaking
Cylinder
and
base
junction is leaking
Significantly
reduced
wiring
Body
tube
longer
liverwort
Warm Remind
1. When install and use our products, please be sure to read the product instruction for
use, be sure to check whether the water purifier filter bottle
2. Please send water purifier no use water purifiers in ball valve switch is closed, for all
the losses resulting from the negligence of customers the company shall not be liable
3. Customers receive products please acceptance of the goods detailed investigation, to
reflect the goods within 12 hours, the products of the company is in good condition,
thank you for your cooperation
Warm Remind
*Buy accessories maintenance services, please contact the local dealer
*If the product is not artificial damage, the company responsible for 1:1 replacement
P-4
Three-way ball valve not installed
Body sealing joints not being: the cylinder does not
matter
Blocked filter
Long-term exposure to sunlight causes algae
reproduction
Check the pad, reinstall
To put the rubber sealing
ring is: using a wrench to
tighten the cylinder
Replace or clean the filter
cartridge
Cleaning the cylinder, dark
place
Publicidad
