System Installation - PUR PUV15S El Manual Del Propietario

Installation Instructions (continued):

System Installation:

WARNING: When handling the UV lamps and quartz sleeves, soft
gloves or a cloth should always be used to prevent oil deposits on
the surface. Oil deposits from your hands can create hot spots on the
surface which may lead to premature lamp failure.
1. Determine a suitable location and ensure mounting of the UV system in the
correct orientation can be completed. In order to install/remove the UV lamp and quartz
sleeve from the stainless steel chamber, ensure the minimum clearance is double the
overall length of the unit (Figure 1).
2. Attach the mounting clamp to the installation structure using an appropriate screw type
for both the weight and material of the surface (Figure 2).
3. Position the UV reactor chamber into the mounting clamp and secure (Figure 3).
4. Install all inlet/outlet plumbing to the system (inclusive of all pre-filtration and valve
set-ups described above).
NOTE: In order to meet NSF 55 certification the flow restrictor that is included
with the UV system must be used to control the flow of water through the UV
chamber. The flow restrictor is designed to thread onto either the inlet or
outlet ports using Teflon sealing tape for the NPT fittings. In most settings, the
system should have a manual shut off valve at the input. The water flows in the
direction of the arrow located on the flow restrictor label.
5. Mount the Electronic Controller in a dry location close to the UV reaction chamber. Install
power cord and lamp harness using drip loops to prevent moisture from travelling along
cable and into Controller (Figure 4).
6. Ensure the quartz sleeve is intact and that the o-ring, VuCap
nut are in position and tightened. Do not overtighten the retaining nuts (Figure 5).
7. Connect the four pins of the UV lamp to the UV lamp plug on the Controller (Figure 6).
8. Insert the UV lamp into the quartz sleeve and secure the VuCap
(Figure 7 & 8).
Figure 5
9. Slowly open the supply valves before and after the UV system and ensure there
are no water leaks.
10. Connect the Electronic Controller to the power outlet, and ensure that both the
Controller display (indicates lamp life remaining) and the green LED illuminate
(Figure 9).
The glow from the UV lamp should also be visible through the VuCap
may not be visible in high ambient lighting.
Your UV disinfection system is now ready for use.
If your system is only being used seasonally, it must be stored properly for the winter.
Disconnect your system from the power source and drain all water from the system.
Before placing the system back in service, disinfection of the household plumbing system is strongly recommended.
5
®
Figure 6
retaining ring and retaining
protective cover
®
Figure 7
® but note it
Figure 1
Minimum Clearance = x2 Unit Length
Overall Unit Length
Figure 2
Figure 3
2"
Figure 4
Drip
Loops
Figure 8
Figure 9
3"