Global Industrial 641410 Manual Del Usuario página 3

WARNING
• Do not operate machine unless you have read
and understand this manual.
• Do not use your fingers to wipe or remove debris
from the blades, as injury may occur.
• Flammable materials can cause an explosion or
fire. DO NOT use flammable materials in tanks as
cleaning agent.
• Always empty Recovery tank before filling
solution tank
• Always empty and clean the recovery tank after
using the machine.
• Do not fill the solution tank before emptying the
recovery tank
• Before performing any maintenance on the
machine, be sure that the power is turned off.
• Repairs are to be completed by Authorized
Person-nel/Service Centers only.
• Do not put any flammable materials into
solution tank. This can cause an explosion or
a fire. Only use approved cleaning chemicals.
Contact Global Industrial (1-800-645-1232) for
recommendations on proper Cleaning Solutions.
• Foam must not enter the float shut-off screen, or
damage can occur to the vacuum motor. Foam
will not activate the machine's float shut-off
device.
PACKAGE CONTENTS
1. Machine
2. Squeegee Assembly
3. Pad Driver
MACHINE SET-UP/OPERATION PRIOR TO EACH USE
1. Always plug into grounded outlet rated 120V/60HZ
2. Check that squeeze assembly is properly installed.
3. Check that the pad driver is properly installed.
4. The working surface is sufficient to support the weight
of the machine.
5. Always close Recovery Tank cover fully before use
GFCI (GROUND CIRCUIT INTERRUPTER) PLUG
WARNING
Before use should be tested to verify that the GFCI
plug can work properly.
, as injury may occur.
• Connect the GFCI plug to the wall outlet
• Press the "rest button", the plug indicator light
will be on , then press "test button", the indicator
light will be off with the "click" (trip) sound. Power
will be off at this lime.
• This test is complete and ready to be used.
17" Electric Auto
Floor Scrubber
SQUEEGEE INSTALLATION
• Loosen the 2 knobs on the squeegee assembly.
• Connect the vacuum hose to the vacuum hole in the
squeegee assembly.
• Align the knobs with the slots and tighten the knobs.
PAD DRIVER/BRUSH COUPLING
• Turn the machine off
• Place the pad driver/Brush under the head assembly.
• Lower the head assembly to the floor by pushing the
control handle forward
• Line up three studs on the pad driver/brush to the holes
on the head assembly
• Turn the machine on
• Press the brush button , brush motor will start working,
and the pad driver/brush will lock in completely
PAD DRIVER/BRUSH UNCOUPLING
Raise the head assembly by pulling the control handle
backward, rotate the brush until it comes out of the
brush-holder plate seat
SOLUTION TANK
• Check water level indicator
for water level
3
Knob
Vacuum Hose
• Remove the solution tank cap and
fill with clean water for regular
cleaning surface. For deep and dirty
surface, Contact Global Industrial
(1-800-645-1232) for
mendations on proper
Solutions.
User's Manual User's Manual User's Manual
Knob
recoma-
Cleaning