Pm Value Equivalent Table; Remote Control - asecos PURIFIAIR.620 Manual De Instrucciones

3.2. PM VALUE EQUIVALENT TABLE

3.3. REMOTE CONTROL

CR 2032
16
Filter function
This device has a function for regularly replacing the filter units. The exchange time is set to 3000 operating
hours. When this number of operating hours is reached, the indicator light on the control panel will be illumi-
nated continuously, prompting the user to exchange the filter components. Press the filter function button to
reset the time.
Press the button briefly: Display the operating hours
Press the button for longer: Reset the operating hours
Cleaning
Plastic mesh pre-filter
Exchange
Multi-component filter units
CAUTION:
Press the filter button briefly to display the operating hours completed. First the thousands
place is displayed, then the hundreds, then the tens, then the ones. The example below
shows the display for 2802 operating hours:
Child safety feature
When the device is switched on, press the "Child safety" button for 5 seconds and the device will switch to
child safety mode. The buttons on the device and remote control cannot be activated in this mode. Press the
button again for 5 seconds to end child safety mode.
Timer function
When the device is switched on, each time the "TIMER" button is pressed, this will extend the run time of the
air purifier by 1 hour. After this time, the device will switch to Standby mode. The maximum duration is 12
hours. Pressing the button a 13th time shuts o the timer.
PM 1.0 capacity g/m³ 5–35
Particle concentration Low (green)
Speed Low speed
Speed level
This product is delivered with a remote control that uses button-cell batteries. Please remove the batteries if
the remote control is not in use for a long period of time. The buttons on the remote control match those on
the control panel. The general functions and operating methods are the same.
Note: Remove the battery cover before initial use (for instance with a coin), and remove the protective film
over the batteries. Then replace the cover. Ensure that the "+" symbol is visible on the top of the
batteries.
Normal
Flashes red
No display
--> Clean the filter
When 3000 operating hours is reached:
No display Illuminated red continuously
--> Exchange the filter
36–75
Normal (blue) High (orange)
Medium speed High speed
76–150 151–500
Very high (red)
Turbo speed