Axxess TYTO-01 Instrucciones De Instalación página 3

CONNECTIONS TO BE MADE
From the 20-pin harness, to the aftermarket radio:
• Connect the Yellow wire to the 12-volt battery/memory wire.
• Connect the Black wire to the ground wire.
• Connect the Red wire to the accessory/ignition wire.
• Connect the Orange wire to the illumination wire.
Note: If the aftermarket radio does not have an illumination wire, tape up and disregard the
Orange wire.
• Connect the 14-pin harness to the TYTO-01.
INSTALLING THE TYTO-01
• With all connections completed to the aftermarket radio, plug the 20-pin harness into the
vehicles wiring harness.
• Reconnect the negative battery terminal.
• Cycle the key, by turning the ignition on for 30 seconds. Then off and on again to test the
radio.
TESTING THE TYTO-01
• Turn the ignition on if not already, and then turn the radio on to verify that the radio
works. Check balance and fader controls for proper operation.
• To adjust the overall volume of your audio system, rotate the potentiometer which is
located on the 16-pin side of the interface clockwise.
3
REV. 12/29/2017 INSTTYTO-01