Ickle Bubba Galaxy Manual De Instrucciones página 10

PLACING YOUR CHILD IN THE GALAXY CAR SEAT
Loosen the shoulder belts by pressing the quick adjuster button,
(A1) and pulling the shoulder belts towards you (A2).
Release the belt buckle and drape the belts with the tongue
sections over the two sides of the seat (B). Pull the buckle for-
ward, attach the loop of the belt pad over the edge of the quick
adjuster button.
Make sure there are no toys or other hard objects in the shell.
Position your baby comfortably in the baby car seat.
Join the buckle tongue sections together and insert them into
the buckle until it clicks (C).
Pull the shoulder belts tight using the quick adjuster belt strap
at the front.
The loop can be secured under the shell rim (D).
Adjusting the height of the shoulder belts
The shoulder belts should run through the slots located directly
above the baby's shoulders.
•Pull the shoulder belts through the slots in the shell and cover.
•Place the shoulder belts back, at the required height.
•Use the same slots in both the shell and the cover.
•Check to make sure the belts can be used properly and that
they are not twisted.
Important
The more tightly the belts are fastened around the child, the bet-
ter the protection. You should be able to fit no more than one
finger between the belts and your child.
The belts should never be twisted or damaged.
When positioning the baby make sure that he/she does not sit
on the belts by hanging them to the side behind the belt hooks.
Hook the belt pad of the belt that goes between the legs behind
the edge of the quick adjuster.
E Removable seat insert
The baby car seat has a removable seat insert (E) to create a
flatter lying position for newborn babies and support the head
in a sideways direction. When the baby is approx. 4 or 5 months
old, remove the filling block (F) to make the seat deeper, then
you can still use the head support. The filling block can be found
underneath the fabric of the car seat, where the child sits.
9
V.01.20