Assembly Instructions - Craftsman C459.627020 Manual Del Operador

ASSEMBLING THE HANDLEBARS
WARNING:
To prevent serious personal injury, do
not connect electric extension cord to unit until fully
completing cultivator assembly.
Before you can operate the unit, you must install the handlebars.
1. When you unpack the unit, hold the handle bar in the position
shown in Figure 1 and slide it onto the lower bars.
2. Align the holes in the handlebar with the holes in the lower bars
and insert the bolts through those holes.
3. Hold the handle in place while screwing the knobs onto the
bolts (Fig. 2).
4. Tighten the knobs to secure the handlebars in place.
NOTE: Do not over-tighten the knobs.
5. Check to make sure the bail is assembled into the switch
assembly (Fig. 1, Inset A).
NOTE: Take care not to pinch the switch cable when positioning
the handlebars.
6. Clip the switch cable to the cable restraint on the lower bar as
shown in Figure 1, Inset B.
6

ASSEMBLY INSTRUCTIONS

A
Fig. 1
Fig. 2
B