Homecraft HCMF4BK Manual De Instrucciones página 9

WARM MILK
1. Place the milk frother upright on a dry, sturdy and heat-
resistant surface near an electrical outlet.
2. Take the lid off and insert the frothing paddle onto the shaft on the bottom of the frother.
3. Fill the jar with the desired amount of milk and put the lid on.
NOTE: Minimum milk capacity for WARMING MILK is 3 oz. Max capacity is 16 oz.
Refer to chart to decide how much milk to put in - type of milk used may vary.
4. Connect the plug into an electrical outlet and place frother onto base.
5. Press the FUNCTION button three times and the WARMING
MILK indicator light will illuminate.
6. Press the ON/OFF button to begin process.
NOTE: This setting will take approximately 135 seconds. The frother will
turn off automatically when cycle is finished. If you want to stop the
frothing process at any moment, press ON/OFF button once.
7. Take frother off base, remove lid and pour out warm milk and enjoy.
CAUTION: Minimum 3 minutes rest time must be maintained between cycles
otherwise frother will stop and will flash, indicating that it needs to cool down.
COLD FROTH
1. Place the milk frother upright on a dry, sturdy and heat-
resistant surface near an electrical outlet.
2. Take the lid off and insert the frothing paddle onto the shaft on the bottom of the frother.
3. Fill the jar with the desired amount of milk and put the lid on.
NOTE: Minimum milk capacity for COLD FROTH is 3 oz. Max capacity is 5 oz. Refer
to chart to decide how much milk to put in - type of milk used may vary.
4. Connect the plug into an electrical outlet and place frother onto base.
5. Press the FUNCTION button four times and the COLD FROTH indicator light will illuminate.
6. Press the ON/OFF button to begin process.
NOTE: This setting will take approximately 50 to 90 seconds. The frother
will turn off automatically when cycle is finished. If you want to stop the
frothing process at any moment, press ON/OFF button once.
7. Take frother off base, remove lid and pour out the froth and enjoy.
CAUTION: Minimum 3 minutes rest time must be maintained between cycles
otherwise frother will stop and will flash, indicating that it needs to cool down.
7