Tru EX-7000 Guia De Inicio Rapido página 2

Optimal distance from a target is 24 to 36 inches.
•
Applicator will shut off once the battery is completely drained of charge.
•
BACKPACK UNIT INSTRUCTIONS
Battery
HARNESS INSTALLATION INSTRUCTIONS
How to attach power pack to harness:
a. Refer to instructions below on how to attach the power
pack to the harness. Following harness installation,
put the power pack on like you would a backpack
and adjust the straps to fit comfortably.
1. Position the hydroelectric hose toward the front of
the system. Open the flap on the harness. Feed it
under the vertical nylon strap attached to the power
pack of the EX-7000 system. Fold it back toward the
harness and match the two sides of velcro, securing
the harness to the power pack.
2. Repeat step 1 for the second strap.
3. Connect the two ends of the side, and squeeze
buckle connectors between the harness and the
power pack.
133 Nursery Lane | Fort Worth, Texas 76114 | 888.534.7001 | Emist.com
®
©2021 EMist is a registered trademark of SanoTech 360, LLC. All rights reserved. EMI-034-21-EX-7000 Quick Start Guide - 022521
Step 1: Gently push
the battery into slot with
battery release button
facing upwards
Step 3: Put the power
pack on like you would a
backpack and adjust the
straps to fit comfortably.
LED
Light
1
Step 2: Gently slide
the tank into the
power pack, once
fully inserted it will
lock into place.
Step 4: The clear LED
light on the back of the
applicator will light up
red when powered on
and high voltage power
system is engaged.
3
2
3