General Safety - BFT Q.BO KEY Nstrucciones De Instalacion

GENERAL SAFETY

- Installation must be carried out by
qualified personnel (professional
installer, according to EN 12635), in
compliance with Good Practice and
current code.
- Before installing the product, make
all structural changes required to
produce safety gaps and to provide
protection from or isolate all crush-
ing, shearing and dragging hazard
areas and danger zones in general
in accordance with the provisions
of standards EN 12604 and 12453
or any local installation standards.
Check that the existing structure
meets the necessary strength and
stability requirements.
- Keep adults, children and property
out of range of the automated sys-
tem, especially while it is moving.
- Do not allow children to play or
stand within range of the automated
system.
- This automated system is not meant
for use by children or by people with
impaired mental, physical or sensory
capacities, or people who do not
have suitable knowledge, unless a
person who is responsible for their
safety provides them with necessary
supervision or instructions on how
to use the device.
- Children must be supervised to
ensure they do not play with the
device. Do not allow children to play
with the fixed controls. Keep remote
controls out of reach of children.
- Do not work near hinges or moving
mechanical parts.
- When cleaning the outside, always
cut off mains power.
12 - Q.BO KEY
USER WARNINGS (GB)
- All cables must be stripped close to
the terminals only.
WIRING
WARNING! For connection to the
mains power supply, use: a multicore
cable with a cross-sectional area of at
least 5x1.5mm
dealing with three-phase power sup-
plies or 3x1.5mm
supplies (by way of example, type
H05 VV-F cable can be used with a
cross-sectional area of 4x1.5mm
To connect auxiliary equipment, use
wires with a cross-sectional area of
at least 0.5 mm
- Only use pushbuttons with a capac-
ity of 10A-250V or more.
- Wires must be secured with addi-
tional fastening near the terminals
(for example, using cable clamps).
- Low-voltage and single-insulated
wires must be kept a suitable distan-
ce from the housing and fastening
screws.
WARNING! safety extra low voltage
wires must be kept physically separate
from low voltage wires.
Only qualified personnel (professional
installer) should be allowed to access
live parts.
THE DECLARATION OF CONFORM-
ITY CAN BE VIEWED ON THIS
WEBSITE: WWW.BFT.IT IN THE
PRODUCT SECTION.
or 4x1.5mm when
2 2
for single-phase
2
.
2
).
2