Harken R27 Manual De Instrucciones página 10

WARNING!
It is essential for safety that the anchor device or anchor point should always be positioned,
and the work carried out in such a way, as to minimise both the potential for falls and potential
fall distance.
WARNING!
In the fall arrest systems it is necessary to verify the absence of sharp edges, which could trailing
or looping lanyards or lifelines.
The design of the fall arrest system must avoid pendulum falls, which could cause post-fall
oscillation of the body with possible impact against obstacles.
• Load angle limitations: IN9606, IN9606.CLEAR,
IN9565, IN9565.CLEAR, IN9608, IN9608.CLEAR,
IN158 and IN158.CLEAR Trolleys - Rail must run
within 5° of horizontal, but can be mounted at
various angles on the vertical mounting structure.
Harken IN9606, IN9606.CLEAR, IN9565, IN9565.
CLEAR, IN9608, IN9608.CLEAR, IN158 and IN158.
CLEAR Trolleys have the ability to handle loading at
an angle up to 15° beyond vertical.
Loads beyond 15° from vertical will overload trolley.
See image at right.
• Load angle limitations: IN10567, IN10567.CLEAR,
IN10614, IN10614.CLEAR, IN10615 and
IN10615.CLEAR Trolleys - Trolleys with wheeled
toggles are designed to run along a surface,
mounted so that the toggle overhangs the edge.
Ensure that the whole wheel width is in good
contact with the surface to which the rail is
attached. Ensure that the surface is strong enough
to sustain the expected working load and wear.
10
Trolley
15°
Trolley with wheeled toggle
Mounted in recess: trolleys with
wheeled toggle for loading over an edge
Mounted on angle: Trolleys with
wheeled toggle face outward
ENGLISH 24/07/20