Recording And Playback - PNI House WiFi550 NVR Manual De Usuario

To delete a camera connected via the Repeater:
Go to the [Repeater] interface above, left-click on the camera you want to delete from the link scheme, choose
[Delete], then [Save].
The camera that was removed from the schema will automatically connect to the NVR after 30 seconds.

RECORDING AND PLAYBACK

Note: In order to register, you need to install a hard disk in the NVR. This product only works with hard drives
specially dedicated to surveillance systems. (Note: The HDD is not included in this kit)
1. Check your Hard Disk. In the main interface, click [System Setup] → [Record] → [Disk].
Notes:
Make sure the hard disk is connected properly.
We recommend formatting the Hard Disk before using it for the first time.
2. Scheduled recording and alarm recording. Go to the [System Setup] → [Record] → [Record] in the
main interface. Choose the channel and recording mode. Click [Apply]. You can copy settings from one
channel to another by selecting [Copy].
3. Manual recording. In the main interface, go to [Manual Record]. Choose the channel you want to record,
then click [Save]
4. Motion detection recording. Go to [System Setup] → [Alarm] → [Channel]. Select "Alarm Type" →
"Motion detection" for the desired channel. Set the sensitivity, area, time, and warning mode: Screen,
Email, or Beep
5
EN