Speedlink RACING DRONE GAME SET Guia Del Usuario página 4

Make sure the drone is powered off (switch on the drone set to
OFF). Plug the accompanying charging cable into the drone and
then connect the cable to a USB port (5V DC, 500mA min.). The
red charging LED will glow. It takes around 30 minutes to charge
the drone, after which the LED will stop glowing. Be aware that the
Using the supplied screwdriver, unscrew the battery compartment
screw on the remote and insert the batteries (2 × AAA alkaline;
not included), making sure you insert them in accordance with the
polarity markings. Replace the battery compartment cover.
Leave the remote powered off (switch set to OFF). Place the drone
on a flat level surface and power on the drone (set switch to ON).
Note: If you intend to use multiple drones at the same time, power
on and connect each drone individually, not simultaneously.
On the remote, pull back on the throttle controller (left controller),
then power on the remote (set switch to ON).
Note: To use Headless mode (see step 9), place the remote directly
behind the drone (facing the drone's blue LEDs) before switching it on.
Push the throttle controller all the way forward and then pull it
all the way back again. The LEDs on the remote and the drone
will remain solid after a few seconds. The connection is now
initial charge may take a little longer.
Wait until the drone's LEDs start to flash.
established and the drone is ready to fly.
EN
1.
2.
3.
4.
5.