Steren VCA-500 Manual De Instrucciones

VCA-500
Voltage detector
Instruction manual
V1110
Before using your new Voltage detector, please read this
instruction manual to prevent any damage.
Put it away in a safe place for future referen.
• Clean with a soft, dry cloth.
• Do not expose to extreme temperatures.
• Before use, always test the Voltage Detector on a known live circuit to
verify proper operation.
Your new Voltage Detector allows you to verify the AC voltage in an easy
and safe way. Quickly detects voltage at control wires, outlets or
conductors from 100 to 240 V ~
Follow an electrical circuit through the walls without breaking them.
Compact design for an easy handle. Use two type AAA batteries.
Caution
BATTERY INSTALLATION
1. Open the end cap by gently prying up/out at
the pocket clip using a small flat screwdriver.
2. Insert two new AAA batteries or with enough
charge paying attention to polarity.
3. Replace the end cap.
AC VOLTAGE DETECTION
1.- Put the voltage detector near to the energy line (around 0,5 cm).
2.- If AC voltage is present and correct, the detector light will flash and the
audible warning will sound.
IMPORTANT
HIGHLIGHTS
SYMBOLS
Double insulation
or reinforced insulation
NOTE
The conductors in electrical cord sets are often twisted. For best results,
rub the probe tip along a length of the cord to assure placing the tip in
close proximity to the live conductor.
The detector is designed with high sensitivity. Static electricity may
randomly trip the sensor.
S1-S
Input:
Voltage sensitivity:
Frequency:
Detection distance:
Over voltage:
Safety: For indoor use and in accordance with Over voltage
Category III, Pollution Degree 2
Before using your new Electronic insect killer, please read
Product design and specifications are subject to change
this instruction manual to prevent any damage. Put it away
without previous notice.
This Steren product is warranted under normal usage against defects in
workmanship and materials to the original purchaser for one year from the
date of purchase.
1.- This warranty card with all the required information, invoice or purchase
ticket, product box or package, and product, must be presented when
warranty service is required.
2.- If the product stills on the warranty time, the company will repair it free
of charge.
3.- The repairing time will not exceed 30 natural days, from the day the
claim was received.
4.- Steren sell parts, components, consumables and accessories to
customer, as well as warranty service, at any of the addresses mentioned
later.
THIS WARRANTY IS VOID IN THE NEXT CASES:
If the product has been damaged by an accident, acts of God, mishandling,
leaky batteries, failure to follow enclosed instructions, improper repair by
unauthorized personnel, improper safe keeping, among others.
a) The consumer can also claim the warranty service in the purchase
establishment.
b) If you lose the warranty card, we can reissue it, if you show the invoice
or purchase ticket.
Name of the retailer
Address
Product
Brand
Part number
Serial number
Date of delivery
In case your product fails or have questions, please contact your
nearest dealer. If you are in Mexico, please give a call to our Call
SPECIFICATIONS
3 V - - - (2 x AAA)
100 a 240 V ~
50 / 60 Hz
0.5 cm
Cat III 600V
Product: Voltage detector
Part number: VCA-500
Brand: Steren
WARRANTY
CONDITIONS
RETAILER INFORMATION
Center. Call Center
01 800 500 9000