Emtec S830 Manual De Instrucciones página 17

Regulatory Information:
Declaration of Conformity
Trade Name: Emtec Limited
Model: S830
This device complies with part 15 of FCC rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
FCC Notice:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio and television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio / TV technician for help.
For customers in Europe
This product conforms to the following European Directives:
89/336/EEC (EMC Directive)
This product complies with EN55022/A1:2000 and EN 55024/A1:2001 for use in the following
areas: residential, commercial and light industrial.
Liability Exemption Statement
1. All the information included in this manual was produced with our careful caution, but there
may still be some errors and mistakes. Emtec will not be held responsible for those
errors and mistakes.
2. As we can't control users' understanding of this manual, Emtec will not be held
responsible for any accident or other loss caused by misunderstanding of this manual. We shall
not be held responsible either for any loss caused by using this product or for any claim by any
third party.
3. Emtec will be held responsible only for the inherent problem of the device
itself, but not for data loss, modification of the device or other indirect loss resulting from
mal-operation of software, maintenance or other accidents. Emtec will not be held
responsible for restoration of any personal data lost.
4. Emtec reserves the modification right of any software, hardware and user manual
of this device without prior notice.