König Electronic HC-KS40 Manual De Uso página 2

DIGITAL MEASURING CUP SCALE
Name and functions of buttons:
0 (zero) Turn on the unit, turn off the unit. When the unit is on, press and hold 6 seconds to tare or reverse
tare for calibrate an empty cup.
M (mode) Change the display mode.
U (unit) Select display unit.
INITIAL SETUP AND BATTERY REPLACEMENT
Setup and basic instructions
Rotate the battery door to "OPEN" and install the battery in the unit according to the indicated polarity. Close
the battery compartment again and turn the unit on by pressing the [0] button. Place the cup on the scale and
check if the display reads 0 gr. (or oz.). Go to calibration if the scale does not read 0 gr. To ensure an accurate
measurement we advise to do this check every time you use the scale. Hold the [0] button for 3 seconds to
turn off the unit, or wait for 5 minutes until the scale automatically goes to idle.
CALIBRATION
To ensure an accurate measurement we advise to always check the calibration of the scale. Do this by
checking the weight of an empty cup. If the display reads more than 0 you have to calibrate the scale.
1) Ensure the cup is empty.
2) Turn on the unit.
3) Make sure the cup is placed steadily on a flat surface. Hold [0] for 6 seconds until "CAL" flashes. Do not
touch or move the cup when "CAL" is flashing.
The display will read "0" when the calibration is completed.
WEIGHT & VOLUME MEASUREMENT
The weight scale is built into the measuring cup and it can measure the weight of your food and display the
volume of your selected ingredients (water, milk, oil, sugar or flour).
Weight measurement
1) Select "SCALE" display mode by pressing [m] repeatedly until the arrow icon is pointing to "Scale".
2) Press [u] to change the weight unit (gram or oz)
3) Put the ingredient into the cup.
4) Place the cup on a flat table to display the weight. Once the weight is shown, you may also hold the cup in
your hand so you can easily read the display.
Volume measurement
1) Select the ingredient (water, milk, oil, sugar or flour) by pressing [m] repeatedly.
2) Press [u] to change to the desired unit if needed.
3) Put the ingredient into the cup.
4) Place the cup on a flat table to display the volume. Once the volume is shown, you may also hold the cup
in your hand for easy viewing.
NOTE: The volume measurement is converted from the weight & the pre-set density of the ingredient by the
processor in the cup. Therefore the volume is an approximate value and not 100% accurate.
Water
Milk:
Oil:
Sugar (granulated sugar)
Flour (all purpose flour – unsifted)
ENGLISH
Density units selection available
1 kg/L mL, CUPS, FL OZ
1.03 kg/L mL, CUPS, FL OZ
0.9 kg/L mL, CUPS, FL OZ
0.84 kg/L GRAMS, CUPS, LBS OZ
0.6 kg/L GRAMS, CUPS, LBS OZ
2