How To Push The Probe Into The Sample; Measurement Step By Step - Wile Cotton Instrucciones De Uso

EN
4.3. How to push the probe into the
sample
Tightly push the probe into the bucket with
analysed material. Ensure the total contact
of the probe with the material.
Tip of the probe must not touch the botton
or the walls of the bucket/ dish.
During the measurement lightly press the
meter.
Before taking the new measurement take
the probe out of the bucket/ dish, loosen
the cotton slightly by turning the layers.
Now you can take a new measurement.
Note: if the tip of the probe touches the
bottom or the walls of the bucket during
the measurement, that means that the
sample was not tightened well enough, so
you sould add additional layers to the dish.
Because of the high inhomogenity of the
material, always take the samples from
different places of the load.

4.4. Measurement step by step

Push the probe to the sample.
Switch on the meter with a single press on
the P-button.
If you can see all the marks, which are
indicated in the picture below, on the
display, that means that the display works
properly and you can use the meter.
11