Rack Mounting A Single Receiver - AKG Acoustics SR 40 Modo De Empleo

received signal is too weak, in order to suppress the related noise
or the residual noise of the receiver while the transmitter is off. Set
the SQUELCH control to minimum before first switching the recei-
ver on. (For details, refer to section 3.8.)
Prior to setting up your WMS 40, check that the transmitter and
receiver are tuned to the same frequency. The easiest way to do
this is to compare the color codes on the transmitter and receiver.
Reflections off metal parts, walls, ceilings, etc. or the shadow effects of
musicians and other people may weaken or cancel the direct trans-
mitter signal.
For best results, place the receiver as follows:
1. Place the receiver near the performance area (stage). Make sure,
though, that the transmitter will never get any closer to the receiver
than 10 ft (3 m). Optimum separation is 16 ft. (5 m).
2. Check that you can see the receiver from where you will be using the
transmitter.
3. Place the receiver at least 5 ft. (1.5 m) away from any big metal
objects, walls, scaffolding, ceilings, etc.
You can either use the receiver freestanding or mount it in a 19" rack
using the optional RMU 60 rack mounting kit.
1. Place the receiver with the bottom panel up on a flat surface.
2. Slide the two supplied side panel moldings (13) with the rubber feet
facing up into the fixing rails on both sides of the receiver from rear
to front.
3. Use the supplied Phillips screws to fasten the side panel moldings (13)
to the receiver.
1. Place a clamping slide (14) on each rack ear (29), checking that the
pegs on the clamping slides (14) engage in the fixing holes on the
rack ears (29).
2. Slide the clamping slides (14) and rack ears (15) into the fixing rails
on both sides of the receiver from rear to front.
3. Tighten the two Phillips screws in the clamping slides (14) CW to fix
the rack ears (15) on the receiver.
4. Use the supplied screws to fix the supplied blank panel to the left or
right rack ear (29).
5. Use the supplied installation screws to install the receiver in the
rack.
1. Fix one rack ear (15) to the outside panel of each receiver referring
to steps 1 through 3 above.
2. Insert a clamping slide (14) with no rack ear (15) into the fixing rails
on the INSIDE PANEL of one receiver.
2 Description
3 Setting Up
Important!
Refer to Table 1 on
page 12.
3.1 Placing the
Receiver
3.2 Mounting the
Feet on the
Receiver
Refer to Fig. 3.
3.3 Rack Mounting
a Single Receiver
Refer to figs.
4a and 4b.
Refer to fig. 4c.
Refer to fig. 4d.
3.4 Rack Mounting
Two Receivers
Side by Side
13