ASG A450 Manual Del Usuario página 6

Specification
AC Input
Battery Type
Cell Count
Charge Current
Cell Terminate Voltage
Circuit Power
Current Drain for Balancing
Dimension
Weight :
This charger is not intended for use by persons (including children) with reduced physical,
sensory or mentalcapabilities, or lack of experience and knowledge, unless they have been giv-
en supervision or instruction concerning use of the appliance by a person responsible for their
safety. Children should be supervised to ensure that they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similar qualified persons in order to avoid a hazard.
This charger is suitable for charging rechargeable LiPo/LiFe/LiHV/NiMH batteries. Do not
attempt to recharge non-rechargeable batteries. Charging other types of batteries may cause
fire or explosion.
Never leave the charger unattended when it is connected to its power supply.
The allowable AC input voltage is 100-240V AC. Never connect it to any other voltage.
Protect charger from dust, dirt and damp.
Never place the charger and batteries connected to it on any form of flammable surface. Never
operate the charger
in the vicinity of inflammable material or gas.
During charging, the battery must be placed in a well ventilated area . Never place the charger
on a carpet or similar surface.
Take great care to maintain correct battery polarity, and avoid short-circuit. Read the battery
manufacturer's instructions and adhere to them strictly.
The charger must only be plugged into an earthed socket-outlet (for portable class 1 battery
chargers for outdoor use)
The connection to the supply mains is to be in accordance with the national wiring rules when
battery chargers for installation in caravans and similar vehicles.
100-240 V
LiPo/ LiFe/ LiHV/ NiMH
LiPo/ LiFe/ LiHV : 2-4S
NiMH : 6-8S
1 A, 2 A, 3 A, 4A ± 10 %
LiPo : 4,2V ± 0,02V / LiFe : 3,6V ± 0,02V
LiHV : 4,35V ± 0,02V / NiMH : -ΔV
50 W
300 mA
69,4 x 110,7 x 40,5 mm
220 g