Publicidad
Idiomas disponibles
Idiomas disponibles
Operational Behavior
Configuration Card
Using a Configuration Card to change enrollment readers output
To change the enrollment reader output you will need a configuration
card.
Power cycle the reader
z
z
After reader has powered up and within 60 seconds present the
z
z
configuration card to the reader.
The reader will confirm the configuration change by:
z
z
2 short beeps
{
z
2 flashes of Red LED
{
z
The reader will then reset itself
z
z
2 green LED flashes + beeps
{
z
1 red LED flash + beep
{
z
3 Red LED flashes + 3 beeps
{
z
The LED will then turn red and stay on, indicating that the reader is
z
z
ready.
RF Field
Every 100ms the RF field turns on and the reader polls for cards. The
13.56 MHZ field is on for approximately 42 ms in the default reader
configuration, which is maximum complexity. The 125 kHZ field is on
for approximately 20 ms in the default reader configuration, which is
maximum complexity.
6 • Schlage • MT20 Enrollment Reader User Guide
Configuration Card
Publicidad
Capítulos
