Klarfit Spreestar Manual Del Usuario página 22

EN
22
Repairs
Your board comes with a repair kit as standard equipment.
1 Cut a piece of repair material large enough to overlap the damaged area by
approximately 1/2", and round off the edges.
2 Apply glue to the under side of the patch and around the area to be
repaired.
3 Too much glue will interfere with a proper repair. Allow adhesive to
become tacky for 2-4 minutes, and then place patch on the damaged area.
Use a weight to apply 3-5 lbs. of pressure for 12 hours.
4 After patch has dried, apply glue around the edges for a complete seal (dry
for 4 hours).