Tabla de contenido
Publicidad
Power supply
The navigator can be powered in four ways: from the internal battery, from the computer through
the data cable, or from the car to the 12V / 24V cigarette lighter.
When not connected to a power source, the GPS navigator is powered by the internal battery.
The icon [
]in the upper right corner of the screen indicates the battery level.
NOTE: This navigator uses an integrated Li-Ion battery that can not be removed. Generally, if
the screen illumination is set to be low and the battery is fully charged, then the device can operate for
up to 3 hours on the battery. Some features (audio, video, high-light, etc.) play more power, which will
obviously reduce operating time to a new power.
Charging with a power adapter
1 . Connect one end of the car charger to the miniUSB of the GPS navigator
2. Connect the other end of the power supply to the cigarette lighter
CAUTION: Please connect the cigarette lighter to the cigarette lighter after starting the car to
avoid possible damage from unstable current at engine start.
Basic operations
Switching on/off
Please press the power button
the hibernation state. When you turn it on again, the machine will return to the operating mode used
before the shutdown
NOTE: If you want to save the battery, you can press the on / off switch to close the device.
Using the vehicle bracket to fix a navigator
Attach the device to the windscreen of the vehicle using the support included in the package for
use when driving.
CAUTION: Carefully place the support on the windscreen. Ensure that the GPS navigator does
not obstruct your road visibility. Ensure that the browser is locked in a proper place, not by accident. Do
not place it in the airbag area.
Using TF Memory card
If you want to play audio / video files or view pictures on your GPS device, you can store the
desired files on a microSD card that you can insert as shown below:
from the top of the browser to stop it. The system enters
[
]
4
Publicidad
Tabla de contenido
