Tabla de contenido
Publicidad
Chimney installation.
By Put the upper chimney into lower chimney .Then pulling out the upper chimney
upwards. Adjust to reach the height required.
Sliding the chimney to adjust the chimney height. When the height you required is
reached, then hang the fixing hole to the fixing screws as showed in below pictures.
Upper chimney
Lower chimney
Drill 2 8mm holes to accommodate the plate II. Screw and tighten the plate II onto
the wall with 2 screws provided.Assembly the chimney onto the unit and fix it with 2
screws.
Rawl plug
Plate II
Warning: Failure to install the screws or fixing device in accordance with these instructions
may result in electrical hazards.
Screw (4mmx8mm)
Screw (4mmx30mm)
5
Publicidad
Tabla de contenido
