Disty distybox 300 Instrucciones De Operación página 13

Function
Send always Keypad Information: This setting has to be used
EN
if your base station is a distybase Duo or other specified ISDN
system.
Factory setting: 0
Set PARK
number
As an option, the registration process can be carried out
using the PARK number of your DECT base station (PARK =
Portable Access Rights Key). This can have up to 15 digits.
The procedure is advisable if the registration process cannot
be completed due to other active DECT base stations. Please
refer to the user's guide for your base station for further
details about PARK numbers.
Factory setting: no PARK number set.
Activate PARK/ARI
number
The PARK/ARI number set under programming point 80/85
is not used during the registration process.
The PARK/ARI number set under programming point 80/85
is used during the registration process.
Factory setting: 0
24
Parameter Other input
code
40 2 #
80 PARK nummer #
81 0 #
81 1 #
Operating instructions
Function
Set ARI number
Instead of the PARK number (see Parameter 80) the ARI number
can be used for subsciption. For input of the ARI number use 31
as prefix.
Factory setting: no ARI number set.
Reset distybox
300
distybox
The 300 is reset to the factory settings.
This means, however, that the
gistered on a base station. All previous settings are deleted.
After unplugging / plugging in the adapter, the
is restarted and reprogramming of the
Reset parameter
distybox
NOTE The 300 remains registered on the base station;
all other parameters are reset to the factory settings.
NOTE After entering the parameter, replace the handset and wait for
distybox
30 seconds. The
Operating instructions
Parameter Other input
code
85 31 ARI #
90 #
distybox
300 is no longer re ‑
distybox
300
distybox
can begin.
300
91 #
will be restarted automatically.
300
25
EN