Assembly Procedures - Italkero Qogir MKIII Manual De Usuario

Remove the heater body and all of the parts from carton, then follow below procedures.
STEP 1 – Attach Cabinet Handle
Attach cabinet screw handle in the hole in the rear panel.
STEP 2 – Attach Castor Wheels
With at least two people carefully title the appliance on to its side to attach the castor wheels.
Using a spanner attach to the castor wheels to base of appliance with supplied nuts and washers.
STEP 3 – Adding Fuel Bed
Note: for this step you will need a small step ladder or platform to give extra height as the fuel beds need to be
installed from the top of the appliance.
Glass or Lava Rock for Pan Burner
This should be done outside.
Cover the burner with either glass or lava rock fuel beds. DO NOT tip the bag of glass or lava rock onto the burner as
the bags usually contain some fine dust which could clog the burner jets. It is better to empty the bags into a suitable
container and then place the glass or rock by hand around the burner. Make sure the area around the pilot light is kept
clear to allow air to reach.

ASSEMBLY PROCEDURES

10