Publicidad
Idiomas disponibles
Idiomas disponibles
Please refer to the following steps to install NetAgent
1. NetAgent Hardware installation
FOR NetAgent-Internal：
1. Turn off the UPS,Look for the INTELLIGENT SLOT on UPS
2. Insert the NetAgent Card into INTELLIGENT SLOT
3. Lock the NetAgent card fixing screw and connect the RJ45 network cable
4. Turn on the UPS
FOR NetAgent-External：
1. Find the RS232 port on the UPS
2. Connect NetAgent to the RS232 port of the UPS using the appropriate cable
(2501/2502/2505)
3. Lock the RS232 connector fixing bolts
4. Connected to RJ45 network cable, connected to DC power transformer
Please check the input voltage and frequency before using the transformer
(NetAgent 9 & II – 9V / NetAgent 9 Mini & Mini – 5.3V)
2. Configure NetAgent IP
1. Install the Netility on the CD
2. Use the【Network Settings】in Netility to set DHCP to obtain IP or fixed IP
3. Log in to NetAgent
□ Use Netility to log in
□ Log in using a browser
4. Install other application software
□
Netility------------------------------- NetAgent configuration software
□
ClientMate-------------------------- Automatic shutdown software
□
SNMPView------------------------- SNMP network management software
□
iMConfig---------------------------- Config management software
□
UPS MIB---------------------------- MIB definition file for SNMP
□
Time Server------------------------ Time calibration program for NetAgent
□
NetAgent Operation Manual in PDF
ENGLISH
1
Publicidad
