Leds On The Ar750S-Dp - Allied Telesis AR750S-DP Guía De Instalación Y Seguridad

AR750S-DP Secure VPN Router

LEDs on the AR750S-DP

The front panel of the router has LEDs that indicate the operational status of
the router, its switch and ethernet ports, and any connected power supply or
PIC card. Further details about the router's operations can be found using the
CLI command show system.
LED
Status
PSU1..2
Status
SYS
Ethernet
0..1
L/A
Ethernet
0..1
D/C
22
State Function
Green The router is ON, and is receiving power from
the PSU as indicated by the LED.
Amber There is a fan or power fault.
Off Normal operation.
Amber Lit briefly during router startup, or if the router
is malfunctioning.
Amber - There is an internal power supply fault in the
3 flashes router.
Amber - The router temperature is too high or too low.
6 flashes
Amber - The router has both an AC and a DC power
7 flashes supply connected to it. The router only supports
dual power supplies when the PSUs have the
same current type.
Green The Eth port has a 100 Mbps link.
Amber The Eth port has a 10 Mbps link.
Flashing Data is being transmitted or received on the Eth
port.
Green The Eth port is operating at full duplex.
Amber The Eth port is operating at half duplex.
Amber There is a collision on the Eth port.
flashing