Super Power YR-BC430B Manual Del Usuario página 65

To unscrew the disc, the same procedure is performed, but the torque wrench is turned
to lock the disc clockwise.
WARNING:
Excessive vibrations of the blade mean that this blade is not installed
correctly. Immediately turn off the engine and check the blade. An incorrectly installed
blade may cause injuries.
– PLACING THE NYLON WYRE (OPTIONAL)
(F6)
W !
ARNING
Never pour fuel into the fuel tank in a closed and unventilated location. Do not pour fuel
in the vicinity of an open flame or a source of sparks.
With the key L inserted, the locking nut of
the locking nut of the disc is inserted, and
the key is turned counter clockwise to
tighten the disc.
1. Push in the retaining latches on the side of the head
and take off the cover
2. Take the spool out of the string trimmer head.
Prepare about 2-3 m of string trimmer line with a
diameter of 2.4 mm.
3. Bend the string trimmer line in the middle and secure
the bend in the groove
4. Wind both ends in parallel on to the spool in a
clockwise direction. Secure the ends of the wound on
string trimmer line into the prepared holes
5. Return the spool back into the string trimmer head and
secure in place with the cover
MIXING THE FUEL MIX