Waste Tray; Troubleshooting - NISBETS ESSENTIALS DA396 Manual De Instrucciones

UK
Scraping
• After each use, scrape the appliance with a soft plastic or wooden scraper to remove excess fat and food.
• If there is an accumulation of burned fat or food, the cooking surface should be thoroughly scoured and
re-seasoned.
Caution:
It is vital that the cooking surface is re-seasoned after scouring.
Do not use steel wool as it may leave shards that could contaminate food.

Waste Tray

• This appliance is featured with a waste tray to collect any liquid or fats that run off during cooking.
• At least once a day, remove and empty the waste tray before washing with warm soapy water. Do not
allow the tray to overfill.
Warning: DO NOT remove the tray during or immediately after use as the contents are still
hot.

Troubleshooting

If your Nisbets Essentials appliance develops a fault, please check the following table before making a call to
the Helpline.
Fault Probable Cause
The unit is not The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Power supply
HEAT indicator Faulty element
light comes on but
Faulty thermostat
appliance does not
Thermostat set incorrectly
heat up
Appliance slow to Cooking surface not clean
heat up
Faulty element
Surface flaking Build up of carbonised food
debris
No power Thermal cut-out switch has
activated
6
DA396_ML_A5_v3_20210526.indb 6 DA396_ML_A5_v3_20210526.indb 6
Solution
Check the unit is plugged in correctly and switched on
Call Nisbets Essentials agent or qualified technician
Replace the plug fuse
Check power supply
Call Nisbets Essentials agent or qualified technician
Call Nisbets Essentials agent or qualified technician
Check thermostat
Clean cooking surface
Call Nisbets Essentials agent or qualified technician
Refer to "Cleaning, Care & Maintenance" section
Press re-set switch on rear of unit
2021/5/26 13:06 2021/5/26 13:06