Check Menu; Instrument Calibration - Navimo Lofrans Galaxy503 Manual De Instalacion Y Uso

5 MENU

5.10 Check menu

Tests
S e n s . C h e c k s
LCD Test
S w . V e r s i o n
W o r k H o u r s
E x i t
Use the (DOWN) or (UP) key to move around the parameters.
Sensor Checks
The purpose of this function is to check the state
of the sensor:
contact open
contact closed
LCD Test
This function switches on all the display's pixels
thus making it possible to perform a check on
them.
Software Version
Indicates the version of the software installed.
Work Hours
Indicates the hours of operation of the winch.
Exit
To return to the settings menu.
1 . 0 1
0
Select with
Sensor Test
Sensor Test
Confirm with
Select with
Confirm with
Confirm with

5.11 Instrument calibration

Before using the instrument the following parameters must be set:
choice of unit of measurement (metres or feet);
Setting of the Rope_Chain function (optional sensor type CMCT-01);
Measure
R e s e t M e a s u r e N o
U n i t s F e e t
R o p e _ C h a i n O f f
E x i t
detection of type of sensor (Standard or Project);
gipsy diameter setting (default value 33 cm) or reduction factor (default value 57);
Standard and X.. Project series
sensor menu
Sensor Calibrat
Barb. Circ. 3 3 . 0
E x i t
Contametri mod. Galaxy 503/703
1000 – 1500 –2000 W Project series
sensor menu
Sensor Calibrat
Red. Factor 5 7 . 0
E x i t
23