Software Installation; Menu Setting - METRICA FLASH c80 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

ANGLE VALUE SHOWS ON THE TOP OF SCREEN
The range of angle is -90° / +90°
Two unit of angle ° and % (slope)
CONNECT TO THE COMPUTER
User can transfer the records from the device to the computer
with cable connector.
User need to install the software "LDM Studio" from the disc
which is offered with d the device. The user can upload the re-
cords to excel . the software interface is as below:
24
Inclination X-Axis

SOFTWARE INSTALLATION

1. Open the folder "set up" in the disc.
Double click on "setup.exe" to install the software.
Operate following the instructions in chapter 2 "one-key in-
stallation" in "readme.doc" or "readme.pdf"
2. Connect the device to the computer with cable connector af-
ter installation.
When open the software it shows the interface of fig12. It is
successfully connected, it will shows "connected" at the left
bottom of interface.
3. Click
or
to control or clear the records.
4. Click
to upload the records to the computer.
Click
to get the records in excel.
Click
to print the records.

MENU SETTING

Enter and exit the menu
Press button
to enter to the menu setting interface.
User can exit by short press
effect but does not recorded.
User can also exit by short press
taken effect and record.
, the alteration can be taken
, the alteration can be

Publicidad

Tabla de contenido
loading

Tabla de contenido