Safety Instructions - Flex LR 1 Instrucciones De Funcionamiento

393.754_LR1.book Seite 8 Donnerstag, 25. Juni 2015 1:49 13
FLEX LR 1
For your safety
Intended use
This laser detector is designed for commercial
use in industry and trade.
The laser detector is designed for receiving and
displaying horizontal and vertical pulsed laser
beams from the following devices:
– FLEX ALC 1-360
– FLEX ALC 2/1
It cannot be used with other laser devices.

Safety instructions

WARNING!
– Follow all safety and operating instructions
in the operating manual for the laser device
used with this laser detector in order to
prevent hazards posed by the laser beam.
– It is not permitted to tamper with or modify
the device. Do not disable any safety
devices and do not remove any information
or warning signs.
8
– Before switching on the device, check for
visible damage. Do not switch on damaged
devices.
– When performing alignment work on ladders,
avoid an abnormal body posture.
Ensure that you have a secure footing and
keep your balance at all times.
CAUTION!
– Do not use the device in the rain.
– If the device is brought from a very cold
to a warmer environment or vice versa,
you should allow the device to acclimatise
before using it.
– If using adapters and tripods, ensure that
the device is screwed on tightly.
– If shipping the device or shutting it down
for a prolonged period, isolate the batteries
or take them out of the device.