Assembling The Rollator; Folding The Rollator; Using The Hand Brake; Adjusting The Height - Graham Field LUMEX RJ4300 Manual Del Usuario

INSTRUCTIONS FOR USE
Please consult a healthcare professional for the proper adjustment.

ASSEMBLING THE ROLLATOR

1. Remove Rollator and other components from carton.
2.
Unfold frame; spread front and back legs apart.
3.
Push down locking mechanism to secure legs in place.
NOTE: Ensure the side crossbars (locking mechanism) lock down.
4. Insert handgrip handle bars into frame.
NOTE: After installation, make sure brake cable is secured to frame
with rollator clip.
5. Secure positioning of handle bars with adjustment knob.
6.
Install backrest into frame and secure with push buttons.

FOLDING THE ROLLATOR

1. If necessary, remove the accessories and lift the seat.
2. Hold one handle and pull up on the Folding Pull Strap that is attached
to the crossbar (locking mechanism) or the pouch underneath the seat.

USING THE HAND BRAKE

Brakes should be used in one of the following methods:
1. To Engage Brake: Push down on lower part of hand brake.
2.
To Remain Stationary: Hold the hand brake up.
3.
To Continue Mobility: Release the brake. To unlock, pull up on the top
portion of the brake handle.
CAUTION: Always lock hand brakes when user is immobile.

ADJUSTING THE HEIGHT

1.
Remove the adjustment knob and bolt by turning counterclockwise.
2. Consult with healthcare professional for proper adjustment.
3. Install the adjustment knob into one of the adjustment holes by turning
clockwise.
4. Repeat STEPS 1– 3 for the other side.
Make sure that the height adjustment is at the same height for both handles
to ensure safety and proper use.
NOTE: After adjusting the height, the brakes of the rollator must be
checked and, if necessary, adjusted.
Handgrip
Locking
Hand Brake
Adjustment
Knob
Detachable
Wire Basket
Rear Leg
Locking
Mechanism
Wheel
Rest Seat
Folding
Pull Strap