Part Names And Functions - Akiyama TA-9600D USB Manual De Instrucciones

PART NAMES AND FUNCTIONS

A B
12
2
FRONT PANEL
1. MASTER VOLUME CONTROL.
Simultaneously control signal level at outputs.
2.POWER SWITCH.
3. SPEAKERS SELECTORS.
These switches control the selection of the speaker
terminals on the rear panel of the amplifier.
A : Sound can be heard on speakers connected to the
speaker terminals marked A on the rear panel.
B : Sound can be heard on speakers connected to the
speaker terminals marked B on the rear panel
4. INPUT SELECTOR.
Just press the button corresponding to the sourcing you
want to hear.
The LED above the selected button will light.
5. BASS EXTENSION SWITCH.
This switch compensates for the non-linear hearing
response of the human ear low volume levels. Set this
switch out ( when listening at normal volume levels.
6. BASS.
Boosts or attenuates the main high frequency sound. The
response is flat when the knob is centered. Treble
attenuated when the knob is rotated counterclockwise and
boosted when rotated clockwise.
7. TREBLE.
Boots or attenuates the main high frequency sound. The
response is flat when the knob is centered. Treble is
attenuated when the knob is rotated counterclockwise and
boosted when rotated clockwise.
8. BALANCE.
Controls the relative volume of the right and left
speakers. When the knob is in the centre click position,
the relative volume is the same for both speakers. This
control allows compensation for the acoustic properties
of the listening area.
F
C D E
9 3 3 10
TA-9600D USB
4 12 5
11
9. PHONE JACK.
8-ohm stereo headphones may be connected to this jack
for monitoring the amplifier output. For private listening
or monitoring by headphones, release both A and B
speakers selectors.
10. MICROPHONE JACK.
Use this jack to connect your dynamic microphone.
11. MICROPHONE VOLUME.
Sets the volume of your dynamic microphone.
12. USB Player
From the Source selector set "USB/AUX". C
data storage device to playback the tracks in it. First
connect your at USB data storage device at connector F.
Then use buttons A, B, C D,E to perform Playback and
Track selection and Volume control
LCD Navigation Display.
ID3TAG LCD Display
The display only displays information about the connected
USB device (F). You can control the volume with (1) the
master volume control.
When you connect the USB device (F) the display shows
the total available songs.
Press Play button (E) to begin to play.
USB CONTROLS
A- NEXT: Press once and go to the next track.
B.- PREV: Press once and jump to the track before the
current one
.
C.- REPEAT: You can chose between to repeat one song,
the displays shows "One", to repeat all the songs, the
displays shows "All" or Play all the songs and turn stop, the
display shows "Off"
D.- STOP: stop the playback and returns to the first song.
E.- PLAY/PAUSE: Press to start playback, and press again
to pause the playback
6 8
7
1
onnect a USB
2