Hardware Installation; Before Installation; Voltage Output - Planet POE-161S Manual De Usuario

5. Hardware Installation

This section describes the hardware features of 802.3at PoE+
Splitter. Before connecting any network device to the 802.3at PoE+
Splitter, refer to this chapter carefully.

5.1 Before Installation

PLANET 802.3at PoE+ Splitter separates the power out and provides
two kinds of DC power output through its DIP switch and its voltage
and current are shown below:
Model
DIP Switch for DC

Voltage Output

Default Mode
Note
DC Receptacle 2.5mm
PLANET 802.3at PoE+ Splitter and PLANET 802.3at
PoE+ Injector (e.g. POE-161, POE-163 and POE-164)
can be installed in pair. Use of third-party 802.3at
PoE+ Injector device is allowed if the device complies
Note
with IEEE 802.3at standard.
POE-161S
CAUTION
Incorrect voltage might
cause device damage
DC Out 5V 12V
5V DC/4.5A
12V DC/2A
5V DC
The diameter of the hole of the
2.5mm
802.3at PoE+ Splitter's DC plug
connector
The POE-161S and POE-162S
provide 5V/12V and 12V/24V DC
power output through DIP switch
setting, respectively.
POE-162S
Incorrect voltage might
cause device damage
DC Out 24V
Ethernet
12V DC/2A
24V DC/1A
12V DC
measures
CAUTION
12V Ethernet
2.5mm.
1-3