Hands-Free Features; Adjusting The Volume; Technical Data - Fontastic Conga Manual Del Usuario

GB
and store them. When the search is finished, the speaker plays the last found
station. You can now use the Forward and Backward buttons to jump between
the stored stations.
Note: The Micro-USB cable acts as an FM antenna, connect the Micro-USB
cable to the Conga's Micro USB connector (8).

Hands-free features

With its built-in microphone, Conga is perfectly suited for use as a
hands-free phone.
Note: High volume can cause acoustic feedback from the microphone.
This leads to echo on the caller side, but not on the speaker phone side.
Answer / Ending /Reject calls
To answer an incoming call, briefly press the Phone button (5).
To end a call, press and hold the Phone button (5) for 2 seconds.
To reject an incoming call, press and hold the Phone button (5) for 2 seconds.
Redial
In Bluetooth mode, press the Phone button (5) twice. The phone will redial
the last outgoing number.

Adjusting the Volume

Press and hold the volume + button (3) to increase the volume.
Press and hold the volume - button (1) to decrease the volume.
LED effect lighting
Conga is equipped with a LED effect lighting, which starts to light up after
switching on. To switch the effect lighting on or off, press and hold the
multifunction button (4) for about 4 seconds.

Technical Data

• BT V 5.0
• Operating range: Up to 10m
• Profile: Hands free, Headset, A2DP/ AVRCP
• BT Frequency: 2.402-2.480GHZ, 2.4G
• Speaker: 2 x 5 Watts + Bass reflex
• 3,5 mm audio line-in
• USB interface
• Micro SD card slot
• FM Radio, 87.5-108.0 MHz
• Power Input: 5V DC
• Built-in Microphone
• Status LED: Blue/Red
• Micro USB Charging port
• Rechargeable 1200 mAh Battery
• Operation time: 2-3 hrs.
• Dimensions: 205 x 78 x 68 mm
• Weight: 450 g
3
No liability is accepted for any damage caused by incorrect operation.
In case you need technical support, please contact our
support-team by e-mail under service@fontastic.eu.
Registration and Safety
Certification/General Information
We hereby declare, that this device carries the CE mark in
accordance with the regulations and standards. It conforms with the
fundamental requirements of the RED 2014/53/EC, EMC directive
2014/30/EC as well as the Low Voltage Directive 2014/35/EC.The full text of
the EU declaration of conformity is available at the following internet address:
www.d-parts.de/Konfo
Note on environmental protection:
After the implementation of the European Directive 2012/19/EC in the
national legal system, the following applies: Electrical and electronic
devices may not be disposed of with domestic waste. Consumers are
obliged by law to return electrical and electronic devices at the end of
their service lives to the public collecting points set up for this
purpose or point of sale. Details of this are defined by the national law of the
respective country. This symbol on the product, the instruction manual or the
package indicates that a product is subject to these regulations. By recycling,
re-using the materials or other forms of utilising old devices, you are making
an important contribution to protecting our environment.
GB
4