FMI Products PT32 Serie Instrucciones De Instalación

pt32, pt36 and pt42 series
triM Kit installation instructions
If any of these pieces are missing or damaged, contact
the dealer where you purchase this kit or FMI PROD-
UCTS, LLC at 1-866-328-4537 for referral information.
You can also visit FMI's technical service web site at
www.fmiproducts.com.
InstallatIon InstructIons
Note: Firebox model may vary from that shown in Figure
2.
1. Remove packaging from three pieces of trim.
2. Locate the two adjusting plates with set screws and two
shims in the hardware packet.
3. Align shim under adjusting plate as shown in Figure 1.
4. Slide one end of adjusting plate/shim in slot on mitered
edge of top trim (see Figure 1).
5. Slide other end of adjusting plate/shim in slot on mitered
edge of side trim (see Figure 1).
Adjusting
Plate
Side Trim
Slot
Shim
Mitered
Edge
Figure 1 - Assembling Trim
Includes Hardware Kit 102865-01
Set
Screws
Top Trim
Slot
Mitered
Edge
6. While firmly holding edges of trim together, tighten both
screws on the adjusting plate using a slotted screw-
driver.
7. Repeat steps 2 through 6 for other side.
8. Place the assembled trim onto firebox cabinet. Align
hanging notches on trim with trim hanging shoulder
screws (see Figure 2). Tap trim firmly into place with
palm of hand or rubber mallet by engaging hanging
notches around shoulder screws. Start at one end of
the trim and work around firebox until all notches are
fully engaged.
Assembled Trim
Figure 2 - Attaching Trim to Firebox
www.fmiproducts.com
Trim Hanging
Shoulder Screw
Locations
Hanging Notches
on Trim