Operation - Pairing Procedure - IOGear GW4K30GH60KIT Guia De Inicio Rapido

Operation - Pairing Procedure

1. The GW4K30GH60KIT with 1 transmitter and 2 receivers have already
been paired from the factory and no additional pairing is required. In case
pairing is required, please follow the steps below:
a. Make sure the video display is turned on.
b. Connect the HDMI cable between the display and the RX/receiver (or
receivers) first, so that the receiver can read the EDID upon powering
up.
c. Connect the RX/receiver (or receivers) to the power supply. The
Green power LED will come on.
d. Turn on the video source.
e. Connect the HDMI cable between the video source and the
transmitter.
f. Connect the transmitter to its power supply. The green Power LED will
come on.
g. The amber Link LEDs from both the transmitter and receiver (or
receivers) will start to blink slow, then fast and then turn solid.
h. Connection is now established and you should be able to see video on
your display.
i. After 2 minutes, if there is no connection to the receiver(s), the
transmitter and receiver LINK LED will turn off. This is an indication
that the unit will be in sleep mode.
10
Operation - Pairing Procedure
2. To add the 2nd receiver to the GW4K30GH60KIT that has already connected:
a. Turn on the display and connect an HDMI cable between the display
and the 2nd receiver first, this is so that the receiver can read the EDID
upon powering up.
b. Connect the power supply to the 2nd receiver.
c. Locate the side of the transmitter where the amber Link LED is off,
press the "Set" button momentarily till the LED starts to flash, then press
again for 3 seconds and let go. The LED will blink slow and then fast,
connection will be established within a few seconds.
d. It is possible that the amber Link LED could swap sides from one side
of the TX/transmitter to the other side. Press the "Set" button again for 3
seconds on the side that the amber Link LED is still blinking.
e. If you add the 2nd receiver within 2 minutes of connecting
GW4K30GH60KIT (refer to the step i. above), the LED at the connector
side maybe still blinking, press the "Set" button for 3 seconds and
connection should be established within a few seconds.
11